Get Your Home Heating System Up and Running Again
Heater problems can happen to anyone at the most inconvenient times. Fortunately, not every heating system issue needs a professional to fix it. Below, we’ve prepared some essential troubleshooting steps that you can use to solve your heater’s problem without ever needing to pick up the phone (although we’re only a phone call away if you do need us)! Here are 3 heating repair tips to get your home’s heating system up and running again.
See If The Thermostat Is Responding.
We know this seems extremely basic, but you’d be surprised how many people discover that their thermostat was the source of the issue. In certain models, dead or dying batteries in the device can cause your system to go haywire or not respond. Your thermostat might also not be receiving power due to a tripped circuit breaker.
Change The Air Filter.
How long has it been since you’ve placed a clean air filter inside your HVAC system? Keep in mind that the more often you run your system, the sooner you’ll need to replace the filter. Dirty filters can cause numerous heater problems, including weak airflow, reduced heating power, and overheating equipment. If your heater’s components get too hot, the system may have an automatic shut-off switch that shuts the equipment down to prevent irreversible damage.
Check The Circuit Breakers.
Even if you own a gas- or oil-burning heating system, there is some part of it that relies on electricity. Go to your home’s circuit breaker panel, and check for any circuit breakers that may have tripped. If you have a heat pump, there will be a circuit breaker for the outside unit and another circuit breaker for the inside unit. If any of the switches have tripped, reset them.
If you need a heating repair service in Juliette, GA, turn to Brian Welch Heating and Air. For more information, call us at (478) 291-5298 today and book an appointment with one of our services!